Hanging cartridge filter unit for above ground pools
- Compact unit with integrated skimmer and inlet nozzle
- For all pools with hand rails up to 30 mm wide
- Height can be adjusted to match water level
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
The hanging cartridge filter unit with integrated surface suction and inlet for all above ground pools. Easy to attach to hand rails. Performance is 1,700 l/h, 20 W, IPX8, electrical connection via 230 V/12 V with transformer, cable length approx. 480 cm. The suitable filter medium for your hanging cartridge filter unit is the filter cartridge (Item no.: 060225). The filter unit can be used with water temperature up to 35 °C maximum.
FAQs from category Cartridge filter systems:
Fill the unit with water and open the air release valve attached to the lid until water runs out. This is how you vent the system. Check all connections and hoses for leaks or holes. Retighten connections or hose clamps, seal them with Teflon tape and replace the defective parts if necessary.
Check the cartridge filter for the degree of contamination and clean it with a garden hose or replace it with a new filter. Check the water level and the height of the suspension skimmer; if the water level is too low, too little water flows into the pump. Vent the system. Open the air release valve on the cover until water runs out.
Check your socket for power, test another socket if necessary. Never run the pump without water, the pump can run dry and burn out. Check the mains plug or the connection cable for damage.
Check the cartridge daily and clean it with a garden hose as needed. If cleaning no longer achieves the desired success, replace it.
No, the filter system may only run when the pool is not in use. On the one hand, there is a risk of injury from the suction nozzle, on the other hand, dirt particles are swirled around during use, which the system cannot filter.
The filter system should circulate your pool water at least twice a day. Our Comfort 75 filter system, for example, manages approx. 8,000 litres per hour and can therefore completely circulate a pool with 19,000 litres once in just under 2.5 hours.