Now add our free items to every order!
From a minimum purchase value of EUR 40, - you can now order the following items for free.

Pool cleanser super, 1,00 l

0755201TD08
Art.
  • For the cleaning of heavy lime deposits
  • Dissolves rust, urine deposits and general dirt
  • For indoor and outdoor pools
  • Perfect for basic cleaning

Sold Out

The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.

€9.99
including 20% VAT, plus shipping costs
In stock
From € 40,- free shipping
Return free of charge

Product information

Pool cleanser super, 1,00 l , UN3264

Strongly acidic basic cleanser for the main- and the spring-cleaning of swimming pools, dissolves limescale

USAGE: Cleaning agent. Pool cleanser super serves for the basic cleaning in spring and dissolves heavy lime deposits, rust and general dirt. For outdoor and indoor use. After use the cleanser must be carefully removed. The cleanser is phenol- and formaldehyde-free

For private swimming pools only.

DOSAGE: Depending on the degree of contamination, apply 1:100 / 1:10 to undiluted with brush or scrubber. Allow to react for at least 10 to 15 minutes. After treatment wash area thoroughly with plenty of water. On fittings apply min. 1: 100 diluted and do not leave longer than 15 minutes. To increase the cleaning effect, use warm water. After cleaning, rinse thoroughly with water. Do not apply in direct sunlight.

07552
GHS05, Ätzwirkung, aetzend
GHS07, Ausrufezeichen, Achtung
Danger

FAQs from category Pool cleaner:

Cause: Lime precipitates, not filtered particlesSolution: Adjust the pH level to 7.2 to 7.4 (by adding pH-Plus or pH-Minus). If there are suspended matters turn off the circulation pump and remove the flakes on the bottom with the pool cleaner after about 10-12 hours. Lime precipitates in the pool water (turbidity, shimmering white coating on the water surface, etc.) usually disappear shortly after adjusting the pH level and after the addition of a flocculants (while the filter system is running - WARNING: prohibited with cartridge filter systems and filter balls; the filter can stick!). Backwash thoroughly. Clean cartridge filter or replace by a new one.

Cause: Faulty filter function, too many organic substancesSolution: Backwashing. If the filter system is calcified, use an acidic filter cleaner. If the filter system is ok, make a shock chlorination, meaning raise the chlorine level of the pool water up to 3 mg/l for a short time. The addition of flocculant is recommended as an additional measure (WARNING: prohibited with cartridge filter systems and filter balls; the filter can stick!). Backwash thoroughly. Clean cartridge filter or replace by a new one.

Cause: Too little disinfectant in the water, algae growthSolution: Adjust the pH level to 7.2 to 7.4 by adding pH-Plus or pH-Minus. Let the filter system run continuously during the first 1-2 days. For disinfection with chlorine: Wipe dead algae from the pool walls. Remove algae from bottom with a brush and an aspirator. Make a shock chlorination, meaning raise the chlorine level of the pool water up to 3 mg/l. The addition of an algae protection is recommended. Backwash thoroughly. The added chlorine has degraded after a few days. Backwash thoroughly. If the water is not clear after 1-2 days, repeat the procedure. Cartridge filter system: Frequently clean or replace the cartridge. Alternatively, empty the pool completely, clean thoroughly and refill. After adjusting the pH value, treat the pool water with algicide to prevent new algae grow.

Cause: Iron deposits in the waterSolution: Adjust the pH level to 7.2 to 7.4 by adding pH-Plus or pH-Minus. Add flocculant. (WARNING: prohibited with cartridge filter systems and filter balls; the filter can stick!)  Extend the filter runtime, backwash the filter system thoroughly. In the case of a cartridge filter system, clean the cartridge regularly and replace it if necessary.

Cause: Inadequate chlorine dosing, non-degraded organic substancesSolution: Adjust the pH level to 7.2 to 7.4 by adding pH-Plus or pH-Minus. After a shock chlorination up to ca. 3 mg/l this smell will disappear after a short time.

Cause: Inadequate chlorine dosing, non-degraded organic substancesSolution: Adjust the pH level to 7.2 to 7.4 by adding pH-Plus or pH-Minus. If there is too little chlorine in the water, increase the chlorine content. If the chlorine content is too high, reduce the dosage or drain the pool water and refill with fresh water. Again, pay attention to the pH value.

Take a bucket of warm water, add the required amount of chemical for your pool and stir well. Then empty the bucket with the mixture evenly into the pool with the filter system switched on (circulating).

The lid of our chemical articles also serves as a dosing aid.

Our chemistry must be equipped with a safety lock for the protection of children. This requires some strength to open.

Safety data sheets are stored with the respective chemical article on our homepage. If you still cannot find what you are looking for, please contact us via our form on helpdesk.steinbach.at.

Important information

GENERAL INFORMATION:This product is to be used exclusively for the purposes stated in the description. The effect starts immediately after use. All dosing instructions base on experience values and are nonbinding. Unsuitable for materials that are not acid-resistant, such as stainless steel, aluminium, tiles, enamel. Before use, test the compatibility on an inconspicuous area.

Store cool and dry in a light-protected and well-ventilated place. Always transport and store the container in an upright, vertical position.

Use biocides safely. Always read the label and product information before use.

Caution

Hazard statements: H290 May be corrosive to metals. H314 Causes severe skin burns and eye damage. H335 May cause respiratory irritation.
Precautionary statements: P101 If medical advice is needed, have product container or label at hand. P102 Keep out of reach of children. P271 Use only outdoors or in a wellventilated area. P280 Wear protective gloves/eye protection/face protection. P301+P330+P331 IF SWALLOWED: rinse mouth. Do NOT induce vomiting. P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER/doctor. P501 Dispose of contents/container to hazardous or special waste collection point.

Contains: Hydrochloric acid, phosphoric acid. (EC) 648/2004: Non-ionic surfactants < 5%, phosphates < 5%.

Symbol photos

The pictures shown are just for reference, the actual product may differ.