Cart Cart

INTEX Solar mat

  • powerful heat output
  • UV and salt water resistant
  • integrated bypass valve

Sold Out

The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.

Notifiy me:

* Mandatory Field

including VAT
This product is available in home improvement stores and online shops.

Vinyl collector, for pleasant, warm water. Ready to use, rollable solar collector for simple fitting. Connects after the filter unit. For increased heating performance, several collectors can be connected in series.

Key data:

  • 120 x 120 cm (L x W)
  • Capacity max. 7,570 l/h
  • Connector Ø 32 mm
  • Only for floor fitting
  • Can be used together with filter pumps with a maximum filter pump power of 250 Watts
  • Integrated bypass set for optimal control of heating power

120 x 120 cm (L x B)
Durchflussleistung max. 7.570 l/h
Anschluss Ø 32 mm
Nur für Bodenmontage
Einsetzbar in Verbindung mit Filterpumpen mit einer maximalen Filterpumpenleistung von 250 Watt
Integriertes Bypass Set für die optimale Steuerung der Heizleistung

Solar mat without accessories, 120 x 120 cm (L x W)
Required quantity for your set: 1
Bypass valve
Required quantity for your set: 1
90° fitting
Required quantity for your set: 2
Seal for hose connection
Required quantity for your set: 5
Plastic hose clamp Ø 32 mm
Required quantity for your set: 2
Connection hose Ø 32 mm, L=510 mm
Required quantity for your set: 5
Adapter A, Ø 32/38 mm mit 2" inner thread
Required quantity for your set: 1
Retracted adapter B
Required quantity for your set: 1

FAQs from category Solar:

May I mount the solar collectors or solar mats on the roof?

In general: For every 1 m difference in height (installation height top edge solar system / filter system) the pressure in the filter tank increases by 0.1 bar. This additional pressure not only reduces the performance of the filter pump, but can also damage the vessel in extreme cases. If you have a performance diagram for the filter pump (only for sand filter systems) check the effect of the additional pressure. The main question is not whether the vessel will burst, but whether there is still sufficient circulation with the existing filter system. For sand filter systems, we recommend a maximum height difference of 2 m. For cartridge filter systems, we recommend that you start with 1 piece of solar collector and slowly expand. Attention! A cartridge filter system does not have the same pump pressure as a sand filter system. In many cases, it already stops with one collector connected. These filter systems are not designed to pump upwards. Place the collector directly next to the filter system on the ground.

The solar mats/collectors do not suck up water, what can I do?

The solar mats must be connected after the filter system and then the filter system must be switched on.

The solar mats/collectors do not work at night, what can I do?

The solar mats and solar collectors only function with solar radiation, the black containers/ mats are heated exclusively by solar radiation. The pool water must be pumped through the mats/collectors with the filter system, which is then heated there.   

The pool is not heated, what can I do?

Check that all connections are correctly connected. Switch on the filter system. Use the maximum possible solar radiation and increase the running time of the filter pump. Cover the pool overnight to prevent heat loss.

Should I use a bypass?

In many solar systems, the diameter for the water flow is reduced and with it the entire circulation capacity of the existing filter system. To eliminate this potential problem in advance, we recommend using a bypass set. This not only regulates the heating output, but also specifically controls the water flow.

Symbol photos

The pictures shown are just for reference, the actual product may differ.