Filter unit Comfort 50

Integrated timer switch
Self-priming filter pump with integrated pre-filter and timer switch
Connectors for all common pools Ø 32/38 mm
7 way valve with solid adjustment lever
Comprehensive range of accessories available

€369.00

Description

The Filter unit Comfort 50 has a circulation rate of 6.600 l/h, the connection is 220-240V~ / 50Hz / 450 W. This filter unit can be used for pools with approx. 33.000 l water content and can be connected to all commercially available installation pools with a hose connection Ø 32/38 mm. The filter unit can be used up to a maximum water temperature of 35 ° C. To maintain crystal-clear and sparkling pool water, the filter system can be operated with filter sand as well as with Steinbach Filter Balls as filter medium.

Technical Information

Water capacity

33.000 l

Circulation rate

6.600 l/h

Pump capacity

8.500 l/h

Connection size

Ø 32/38 mm

Power supply

220-240V~ / 50Hz

Input power maximum

450 W

Function principle

self-priming

Head

9,00 m

Pre-filter

yes

Suitable for salt water: yes

Kesselgröße (ø): 415 mm

Valve type: 7-way valve with pressure gauge

Schalldruckpegel: 70 dB(A)

Water temperature: 10°C

Usable filter medium 1: Quartz filter sand

Quantity of usable filter medium 1: 15 kg

Sand grain size: 0,70 mm

Usable filter medium 2: Filter Balls, Filter Wool Flakes

Quantity of usable filter medium 2: 400 g

Usable filter medium 3: no

Pump article number: 040916

Trafo inkludiert: no

RCD inkludiert: no

Timer present: yes

Safety class: IPX5

Protection class: I

Isolierstoffklasse: F

Cable length to unit: 1,50 m

Article number: 040200

Please note that the products shown represent the current scope of delivery, as of 2026.

FAQ

Set the timer on the filter pump to 24 hours. The filter pump is started and stopped with the external timer.
Make sure that you have previously activated the memory backup function of the timer. The following steps must be observed:

Make sure that the power cable of the pump is disconnected from the power supply.
Use a PH1 Phillips screwdriver to remove the screws from the timer cover and remove the cover.
Pull out the plastic strip that can be seen underneath the battery.
Screw the cover back on again. The timer's memory backup function is now activated.

The memory backup function draws the required energy from the pump battery when the mains supply is switched off. Please note that the battery life - depending on the daily operating time - may be limited to a few weeks.