Steinbach
Solar covers for circular pools
- Heats your pool using the power of the sun
- Reduces evaporation of the water
- Saves up to 70% of heating costs
- Less cleaning and use of pool chemicals required
- Professional quality thickness of 300 µm
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
These solar pool covers offer you a simple and economical way to heat your pool with the power of the sun. These insulating covers can be used with all swimming pools up to this size.
Benefits for you:
- For maintaining water temperature
- Rapid heating
- Water can be 3 - 5 °C warmer
- Extend the swimming season
- Professional quality thickness of 300 µm
- Simply place on the water
- Can be cut with scissors
Dimension: Ø 600 cm
Material thickness: 0,30 mm / 300 µm
FAQs from category Solar covers:
No, the manufacturing dimension can deviate due to the material, ambient temperature, etc.
The side with the air knobs must be on the surface of the water.
The small holes in the centre of the solar cover are for safety (same concept as the pool cover). In addition, small holes are distributed near the edge of the solar cover. Sometimes you may notice that the holes are not evenly spread. This will not affect the efficiency or life of your solar cover.
A 305 cm solar cover fits a 305 cm Frame Pool or Easy Pool; however, this does not mean that the solar cover has a diameter of 305 cm. Please bear in mind that there are two different values for the dimensions of solar covers.
No, due to the sun's rays and the lack of cooling by the water, the air knobs can burst.
With the straps and plastic plates included in the scope of delivery, the solar cover is directly connected to the retractor. This allows any type of solar cover to be attached. The solar tarp can be reinforced on the fastening side, but this is not mandatory. The distance between the straps and the retractor must be long enough for the solar cover to lie completely on the water surface when unrolled.
With this solar cover reel, the solar cover is connected to the aluminum shaft using rubber bands. For this to work, the solar cover must have eyelets on one narrow side. If this is not the case, it can be retrofitted with plastic eyelets at any time. There are plastic eyelets in the well-stocked hardware store. A connection without plastic eyelets is not possible, otherwise the solar cover will tear open.
In connection with this roll-up device, eyelets must be placed in the solar cover. These eyelets should always be mounted on the short side. E.g. for a solar tarp for an 8 x 4 m pool, the eyelets are mounted on the 4 m side.
Unfortunately we do not offer custom-made products.