Steinbach
Heat pump Waterpower 5000
- Titanium heat exchanger suitable for salt water
- Can be retrofitted at any time
- Heating and cooling function
- Environmentally friendly R32 gas
- Bypass set (art. no. 060045) recommended
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
Thanks to the Waterpower 5000 heat pump with heating and cooling function, you can adjust the water temperature perfectly to your well-being. The heat pump impresses with minimal maintenance, integrated control via LCD display and a cooling function at no extra charge. Due to the built-in titanium heat exchanger, the heat pump is also ideally suited for salt water pools. The salt concentration must not exceed 0.50 % (corresponds to 5 g/l or 5,000 ppm).
For an even more efficient use of the heat pump, we recommend our Steinbach bypass set (art. no. 060045). With this set, you can regulate the water flow and the water circuit individually.
Water capacity: 30.000 l
Minimum water flow rate: 3.000 l/h
Dimension: 70 x 26,50 x 51,50 cm
Salt water suitable: yes
Connection size: D 50/Ø 38 mm
Heating power*: 5.100 W
Input power heater*: 840 W
Heating input current*: 3,60 A
Cooling possible: yes
Cooling capacity*: 3.400 W
Cooling input power*: 1.150 W
Input current cooling*: 5,20 A
Input power maximum: 1.200 W
Input current maximum: 5,80 A
Power supply**: 220-240V~ / 50Hz
Performance coefficient COP heating: 6,10
Energy efficiency ratio EER cooling: 3,70
Protection class: I
Protection class: IPX4
Flow sensor: yes
Sound pressure level (10 m): 39 dB(A)
Suction pressure nominal: 0,70 MPa
Suction pressure maximum: 15 MPa
Delivery pressure nominal: 3,00 MPa
Maximum discharge pressure: 4,30 MPa
Refrigerant: R32
Refrigerant charge maximum: 320 g
Global Warming Potential GWP: 675
CO2 equivalent: 0,22 t
Water temperature: 5°C - 45°C
Ambient temperature: 5°C - 50°C
Timer present: no
Cable length to unit: 1,45 m
*variable - depending on the environmental conditions
**single-phase alternating current
FAQs for Heat pump Waterpower 5000:
The second cable gland enables the direct connection of a further electrical consumer to the connection box of the heat pump. The direct connection may only be carried out by a qualified electrician, taking into account the maximum power consumption and dimensioning of the cable cross-section.
