INTEX
Fiber Ball
- 0.5 kg Fiber Balls = 18 kg filter sand
- More efficient than filter sand
- Excellent dirt holding capacity
- Easy handling
- High energy efficiency
- 500g content per package
Sold Out
The selected product is currently not available. As soon as the product is on stock, we will send you an E-mail.
Product information
The INTEX Fiber Balls are ideal for commercially available sand filter systems and convince with their efficiency and excellent dirt-holding capacity. They are characterised by an exceptionally long durability and energy efficiency. A special advantage: The Fiber Balls can be effortlessly cleaned in the washing machine. With only 0.5 kg of these balls, the performance of 18 kg of filter sand can be achieved. Please note that the Fiber Balls have been developed as an optimal alternative to conventional filter media such as sand or glass and are not suitable for cartridge filter systems. Experience first-class pool filtration with the INTEX Fiber Balls!
Salt water suitable: yes
Filter fineness: 20 μm
Bulk density: 1,38±0,05 g/cm³
Care instructions: Hand washing, not suitable for backwashing
Expected service life: depending on conditions of use 3 months - 6 months until replacement/cleaning
Package contents:0,52 kg
FAQs from category Filter Balls:
This is basically possible without any problems. When using sand filter systems, however, pay attention to the proportions: 700g filter balls correspond to 25 kg filter sand. Please also note that you must not backwash with filter balls, as this can cause filter balls to get into the system and cause damage.
Depending on the degree of soiling, Filter Balls should be cleaned with the garden hose approx. every fortnight and dried in the sun.
Do not put Filter Balls in the washing machine or dryer. The Filter Balls become much smaller when wet and can get behind the drum and damage the machine.
Backwashing would pull the filter balls into the lines and clog them. The resulting pressure in the filter tank would be too high and could damage the filter tank.
All Steinbach and INTEX filter systems (sand filter systems, cartridge filter systems & filter pumps) are suitable for salt water as long as the salt content in the water is below 0.5 % (salt electrolysis). Before winterising, clean the filter system thoroughly with standard bathroom cleaner, clear tap water and a lint-free cloth.
All filter systems and filter pumps have a sound pressure level* of < 70 dB(A).
*The emission volume is comparable to a large household appliance.
If the pressure is too low, the pre-filter is dirty and the pump is not getting enough water. Clean the pre-filter and check the suction line and the water level.
If the sand is newly filled in, or the sand is already very fine due to the use of several seasons, small sand particles may still be present. The solution is to backwash several times until the water comes out clear, or to fill in new sand.
The filter system should always be the first part in the water treatment system. The rest of the pool accessoires should only be connected after the filter system. A heat pump should ideally always be the last part in the water treatment system, so that the filtered, treated water flows through the heat pump and the path of the heated water into the pool is as short as possible.